Fits 1960–77 Ford and Mercury vehicles with small block Windsor engines (260 / 289 / 302 cubic inch).
This satin-finish aluminum intake manifold by Speedmaster® is a dual-plane, low-rise with a height of 4.12 inches. The basic operation ranges from 1,500 to 6,500 RPM. Ideal for street performance vehicles. Designed to improve throttle response along with power and torque over the full RPM range, and its low-profile design gives good hood clearance.
Will not work with O.E. spread bore carburetors.
NOTE TO CALIFORNIA CUSTOMERS: This product is legal for off-road use and non-pollution-controlled vehicles (1965 and older). However, it has not been tested or approved by the California Air Resources Board for highway vehicles in the state of California. By purchasing this item, the buyer agrees it will not be used on pollution-controlled vehicles in California, or in any other state with similar emission regulations.
This satin-finish aluminum intake manifold by Speedmaster® is a dual-plane, low-rise with a height of 4.12 inches. The basic operation ranges from 1,500 to 6,500 RPM. Ideal for street performance vehicles. Designed to improve throttle response along with power and torque over the full RPM range, and its low-profile design gives good hood clearance.
Will not work with O.E. spread bore carburetors.
NOTE TO CALIFORNIA CUSTOMERS: This product is legal for off-road use and non-pollution-controlled vehicles (1965 and older). However, it has not been tested or approved by the California Air Resources Board for highway vehicles in the state of California. By purchasing this item, the buyer agrees it will not be used on pollution-controlled vehicles in California, or in any other state with similar emission regulations.
| ⚠️ | WARNING: This product can expose you to chemicals, including lead, DEHP, and other chemicals which are known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65Warnings.ca.gov . |
