This drive shaft slip yoke for a small-block V8 has 28 splines and uses an outer lock ring.
- Measurements (please refer to diagram):
- (A) Length from center of u-joint hole to end of shaft: 8-3/32 inches
- (B) Outside to outside width of u-joint: 3-1/2 inches
- (C) Outside diameter of shaft: 1-1/2 inches
- (D) Inside diameter of the shaft to the spline: 1-9/32 inches
- (E) Inside diameter of the spline: 1-3/32 inches
- (F) Splines: 28
| ⚠️ | WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov . |
